![]() declares that the radio equipment type Ember Mug 2 is in compliance with the relevant statutory requirements. The full text of the EU declaration of conformity is available at the following internet address: UK DECLARATION OF CONFORMITY STATEMENT declares that the radio equipment type Ember Mug 2 is in compliance with Directive 2014/53/EU. The separate collection and recycling of your waste equipment at the time of disposal will help to conserve natural resources and ensure that it is recycled in a manner that protects human health and the environment.įor more information on where to drop off your waste equipment, please contact your local city office, your household waste disposal service or the place where you purchased the product. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the recycling of waste electrical and electronic equipment. The symbol above, on the product, its batteries or packaging, means that the product and its batteries must not be disposed of with your household waste. ![]() This product is subject to European Union regulations that promote the re-use and recycling of used electrical and electronic equipment. Information on application of EU WEEE Directive You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.įor further information on consumer rights in Australia, visit and You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. ![]() Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. This device must accept any interference, including interference that may cause undesired operation of the device.This device may not cause interference.Operation is subject to the following two conditions: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). INDUSTRY CANADA STATEMENT: CAN RSS-GEN/CNR-GEN
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |